Honda S2000 (2006-2009) BlueMAX Injector Set: 4 x 2150cc

Fits Honda S2000 (2006-2009)

BEFORE ORDERING: For aftermarket or other unusual setups please email us, prior to placing your order, to make sure you receive injectors that fit properly.

Great injector for E85 or other high volume fuels! These injectors do not require a resistor pack or P&H drivers.

WARNING: DO NOT USE WITH VP Import, Q16 or OTHER MTBE OXYGENATED FUELS! The internal construction of this 2150cc/min injector includes a seal that has been found to swell when in contact with MTBE from oxygenated fuels like Q16 or VP Import. This swelling causes a significant reduction in flow through the injector and therefore renders it unsuitable for use with MTBE oxygenated fuels. Please be sure to follow the care instructions for these injectors since there are potential corrosion issues that may arise from prolonged disuse while exposed to alcohol based fuels (E85, etc.).

This massive injector is in a class of its own when low end throttle response and short pulse width control is required. State-of-the-art Data Match Technology dynamic flow matching is used during the production of these injector sets due their large flow rate. This significantly improves the ECU's ability to control these injectors in the sub 2ms pulse width area, typical of idle and part throttle conditions.

It contains high impedance injectors, matched to the saturated injector signal, generated by this vehicle's OEM ECU, OR is suitable for use with an aftermarket ECU made or set up for high impedance injectors.

Fuel Injector Clinic injectors are flow tested and rated at 43.5psi (3Bar) at 90ºF fuel temperature using CF-16B calibration fluid.

Each injector is individually serial numbered and the results are provided on the Data Match Sheet providing the most complete flow matching and latency value information available in the industry today.

Fuel Injector Clinic injectors are set up to and include all o-rings needed to fit the factory application for the listed vehicle. Every injector is covered against failure caused by defects in original manufacture by our 12-month warranty.

Includes pigtails PGT DEN4 or add Plug & Play adaptors PADPDtoH4.

INSTALLATION NOTES: This set of injectors requires you to change the injector plug on the wiring harness in your car. This can be done by soldering in the pigtails (included with purchase) to replace the plugs currently on your harness, or you can choose to purchase the optional plug-n-play adaptors which will convert from the type of plugs on these injectors to the plugs on your harness without any need for cutting or soldering.This plug conversion is made necessary because FIC always chooses to provide brand new, unused injectors for its performance applications.